Author Topic: help determining which product needed  (Read 71 times)

pattipat

  • Newbie
  • *
  • Posts: 2
    • View Profile
help determining which product needed
« on: September 03, 2017, 01:01:19 PM »
I've just discovered this product and am very excited about the possibility of using it in my new home.  This will be a retrofit, 2 x 4 wall with vent going down.  It appears I need a 3D for the downward vent, but I'm unsure, from what I've seen on this website, if this is a retrofit product.  I'm reasonably handy, should I be able to install this by myself?

Thanks,
Patti

rickharp

  • Administrator
  • Full Member
  • *****
  • Posts: 146
  • Gender: Male
    • View Profile
    • http://www.dryerbox.com
Re: help determining which product needed
« Reply #1 on: September 14, 2017, 11:50:33 AM »
As long as the dryer is not "stacked" or on a pedestal, then the 3D is the right receptacle. 
It can be "retrofitted", meaning, it can be mounted onto the drywall instead of mounting the unit onto the studs and doing hours of drywall repair. 
See the images at this link, especially picture series number 5

https://dryerbox.com/dryerbox-installation-pictures.htm

Rick Harpenau
In-O-Vate Technologies, Inc
Jupiter, FL  33477
561-743-8696

pattipat

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: help determining which product needed
« Reply #2 on: September 20, 2017, 05:46:31 AM »
Thank you so much for your help.  I need to do a little more investigating to be sure what is located where in that wall, but hope to try this soon.

Thanks again,
Patti