Lint Trap and roof or soffit mounted vent

Dryer venting

Author Topic: Lint Trap and roof or soffit mounted vent  (Read 7786 times)


  • Newbie
  • *
  • Posts: 1
    • View Profile
Lint Trap and roof or soffit mounted vent
« on: December 31, 2012, 02:56:41 PM »
I am installing a new dryer vent in my home. I plan on going on a soffit vent or the Dryerjack vent for efficiency. If the exhaust goes vertical would that cause lint to settle in the dryer flex hose? would I need to install a Lint Trap, and if so wouldn't I lose efficiency?


  • Administrator
  • Full Member
  • *****
  • Posts: 158
  • Gender: Male
    • View Profile
Re: Lint Trap and roof or soffit mounted vent
« Reply #1 on: January 02, 2013, 11:40:47 AM »
Good question. 
Hot air likes to rise, so going up is not a strain. 
Lint would settle if there was not good flow.  Poor flow, or conditions that you bring up usually occur due to very inefficient roof vents.  The Dryer is very capable, especially the new ones, at pushing air and any lint particles to the exterior. 
For the soffit vent, it is neat, but make sure it is not near an AC compressor, or windows and doors. 
Limit the number of bends. 
I am fond of either vent.  Not fond of the Lint Trap though for your application.  Keep the airborne particles airborne with zero resistance at the termination.  Thanks for asking. 
Sounds like you aready watched the DryerJack video...
In-O-Vate Technologies, Inc
Jupiter, FL  33477